Stop Codes During Install

[mchldpy]

Hey,
On a separate machine while trying to install a proven disk I get Stop Codes "0x0A", (10 characters) "0x80" (16 characters) and "0x02". (16 characters)
It happens while setup is collecting info just before "Installing Files" starts. Once it got to 2% installing files with DVD and once it got to 80% installing files using same setup files on a USB Flash Drive. I don't think the 80% was correct because there was only a little over a GB worth of files on the drive.
I've tried the on-board and discreet graphics, both CD Burners individually, no CD Burners.
I'm tired of looking at GParted and it's tired of looking at me.
Thank for any ideas.

michael clyde

 

[Snick]

Hi mchldpy,
Expound on proven disk please!

 

[mchldpy]

heysnick,
Proven Disk = the machine I'm speaking to you from. The only se7en install media I have. Fresh copy from the .iso file. I tried it on this machine (2x Gigabyte® GA-MA785-US2H MB) and it completed fine. (again) The trouble is on a new Gigabyte® GA-MA785-UD3H MB. It's now informing me at reboot, when it should boot from the new install, that the BCD/Boot Configuration is not right so ...