Windows 7 Installation problem. Loop to beginning.

S

saeoh

New member
Local time
2:01 PM
Messages
2
Hello,

I have Fujitsu Lifebook UH-572.
i5-3317u
4gb ddr3
intel hd4000
32gb ssd
500gb WD Blue (this is C:\)

I swap the WD with Samsung SSD 840 and did fresh installation of Win7 Home Premium 64bit. When install is done and does the first reboot, it goes back to initial installation screen. I disabled USB (Win7 was installing from USB) during reboot and the screen brings me to selection of bootable device. There is only Samsung SSD and when the SSD is selected, nothing happens and just keep prompting the selection screen.

So I tried to boot from usb to do repair. After scan, there is installed windows on the partition however, repair attempt suggest to remove recently installed hardware.

Is there anything else I can try?
 

My Computer

Computer type
Laptop
Computer Manufacturer/Model Number
Fujitsu uh-572
OS
win7homepre64
CPU
i5-3317u
Memory
4gb hynix
Graphics Card(s)
intel hd4000
Hard Drives
500gb wd blue
Try "startup repair" again. After it's finished click "Click here for diagnostic and repair details".
It shows the tests it did. Status 0x0 means no error (not interested in that).

What tests had errors and what error?
 

My Computer

Computer type
Laptop
Computer Manufacturer/Model Number
ACER ASPIRE 5742G
OS
Microsoft Windows 7 Home Premium 64-bits 7601 Multiprocessor Free Service Pack 1
CPU
Intel(R) Core(TM) i3 CPU M 370 @ 2.40GHz
Motherboard
Acer Aspire 5742G
Memory
4,00 GB
Graphics Card(s)
ATI Mobility Radeon HD 5400 Series
Sound Card
(1) AMD High Definition Audio Device (2) Realtek High Defi
Screen Resolution
1366 x 768 x 32 bits (4294967296 colors) @ 60 Hz
Hard Drives
WDC WD5000BEVT-22ZAT0
Non there than 0x0

All test result shows 0x0.
It even says "boot status indicate that the os booted successfully"
 

My Computer

Computer type
Laptop
Computer Manufacturer/Model Number
Fujitsu uh-572
OS
win7homepre64
CPU
i5-3317u
Memory
4gb hynix
Graphics Card(s)
intel hd4000
Hard Drives
500gb wd blue
Boot again from the usb stick. Select "command prompt"

Code: 
diskpart
list vol
exit

What is drive letter of OS partition on SSD? In this example I use F
Code: 
bcdboot  [COLOR=red][B]F[/B][/COLOR]:\Windows

Command succesfull? If so:
Code: 
bootsect /nt60  [B][COLOR=red]F[/COLOR][/B]:  /force
bootsect /nt60  [B][COLOR=red]F[/COLOR][/B]:  /force  /mbr
Reboot again from usb stick. Now you see a bootmenu. Select "windows 7". Does it boot to SSD?
 

My Computer

Computer type
Laptop
Computer Manufacturer/Model Number
ACER ASPIRE 5742G
OS
Microsoft Windows 7 Home Premium 64-bits 7601 Multiprocessor Free Service Pack 1
CPU
Intel(R) Core(TM) i3 CPU M 370 @ 2.40GHz
Motherboard
Acer Aspire 5742G
Memory
4,00 GB
Graphics Card(s)
ATI Mobility Radeon HD 5400 Series
Sound Card
(1) AMD High Definition Audio Device (2) Realtek High Defi
Screen Resolution
1366 x 768 x 32 bits (4294967296 colors) @ 60 Hz
Hard Drives
WDC WD5000BEVT-22ZAT0
Try removing the USB stick during install after the first reboot. It is obvioulsy interfering.

If this fails enter Device Manager to disable any devices showing in error (!): Device Manager - Access During Windows 7 Installation

If that fails reset the BIOS to defaults, set SATA controller to AHCI, HD to boot first.

Is this an EFI BIOS? UEFI BIOS vs. Legacy BIOS - YouTube
UEFI (Unified Extensible Firmware Interface) - Install Windows 7 with - Windows 7 Forums
UEFI Bootable USB Flash Drive - Create in Windows
 
You must log in or register to reply here.
Back
Top